Specific Vessel Specifications and Dimensions/Ratings" LENGTH: 20’ 3” BEAM: 7’ 8” FLOOR WIDTH: 5’ 5” DRAFT: 6-8" HULL WEIGHT: 1,800 lbs. PERSON LOAD: 1,350 lbs. MAX. H.P: 115 H.P. SHAFT LENGTH: 25" HULL TYPE. 100% Composite Construction FUEL CAP. 25 gal. PERSON CAP. 9 Hull Specifications: Unsinkable hull constructed with a commercial or heavy-duty level of 100% Composite Construction with Fiberglass stringer grid- suitable to provide above average strength and durability. Accu-Track hull for sure turning and handling. Hull design must be flat bottom with a short, centerline skeg to provide the ability to make tight turns without sliding. The exterior of hull and interior must be constructed with a heavy duty or commercial level laminate capable of withstanding extreme and harsh continuous use for its expected life span. This must be an upgrade above the normal recreational user standards. No wood materials may be used within the construction process. Any fasteners penetrating the deck or hull must be properly sealed with marine grade adhesive and sealant. Stainless steel bow eye with internal lifting eye, two aft transom eyes capable of light towing and securing the vessel to the trailer. Heavy duty commercial rub rail constructed from a material that will not become brittle or deteriorate over time in the sun. The rub rail should be fastened with screws and bolts completely covered. If the rub rail is fastened with exposed screws or bolts they need to be stainless steel, and bolted on using bind post nuts that are completely flush with the boat so no net can catch on them. The exterior and interior of the boat to be color white. The transom must be high density fiber core foam. Interior Specifications: A molded nonskid deck. A large forward front deck with non-skid decking. Gunnel walls and floor deck shall meet at 90-degree angles. Seating: There is to be no stand-alone seat behind the console to allow for more deck space. Jump seats will be on either side of the back deck, and hatches for storage on these seats will be water tight. Console: Heavy duty fiberglass center console with 360 degrees walk around capability. The medium size console will be set back on the boat- 2.5 feet after the jump seats to create more forward deck space. There is not to be a seat on the front of the console. Windshield with grab rail is needed on console. Navigational lights will be placed on either side of the console. There will be a water tight helm fold-down storage hatch on the console. Console will have lower hatch for battery access and upper hatch to contain battery disconnect switch and accessory switch panel. Fire Extinguisher flush mounted into console.
