● Procure security cameras and necessary hardware ○ Vendor will be required to ship equipment directly to their own facility. ○ Vendor may store a limited supply of cameras at each site based on current needs. ○ Vendor will be responsible for all hardware stored at each site. ○ Vendor must provide a detailed report of any items being stored at each site. ● Install-terminate-patch-test-label yellow, plenum rated category 5e or greater, cabling to all cameras from each IDF ○ Existing patch panels may be used when space is available. ■ Additional modular panels and jacks will be supplied by vendor ○ Install 10’ service loop at camera end ○ Camera end must terminate into a surface block or biscuit jack ■ Vendor will provide and install patch cable from block/jack to camera ○ Patch panel must be labeled with matching camera number ■ Number cameras starting at V101, V102, ect. ● If available, existing ethernet cable to existing camera may be used if it meets the following requirements ○ Plenum rated category 5e or greater ○ Proper termination of all pairs, tested and correctly labeled at the patch panel ○ Estimates or counts are not available of existing cable types ● Provide 1’ yellow bootless patch cable for all cameras ○ Leave 1’ patch cable in patch panel for final install by District personnel ○ Do not plug into switch ● Remove existing camera, camera housing and any mounting hardware ○ Existing non-compatible cabling is not required to be removed. ● Properly mount and secure all security cameras in a manner similar to and in proximity to existing cameras ○ Example, wall mount to wall mount, grid mount to grid mount ■ Exception: All outdoor cameras will be arm mounted regardless of current mount status ■ Additional indoor exceptions will be noted ○ Camera must be installed so that lens is pointed in the same direction as existing camera ● Connect all cameras to newly installed network cabling ● Label the exterior housing of all cameras with the MAC address and camera number ○ Two separate labels must be used, one for the MAC address and one for the camera number ○ Replace the colon with a hyphen in all MAC addresses ○ Typewritten adhesive label required ○ Label must be white with black print ○ Labels must be read left-to-right if standing at the floor facing camera ○ Labeling must be approved by District prior to start of installation...
