Men's Small-XL; Men's 2XL; Men's 3XL; Men's 4XL; Men's 5XL; Women's Small-XL; Women's 2XL; Women's 3XL; Women's 4XL; Women's 5XL; COLLAR & STAND: Collar points to measure 3” long with ultrasonically fused-in Mylar stays positioned along the edge. Collar to have woven fusible interlining. Stays to be 2” long, 3/8” minimum width and to be fused to the bottom ply of the collar and shall be positioned along the leading edge. Stays applied directly to collar material itself unacceptable. Collar height at rear 1-1/2". Collar topstitched with ¼” along the edge. Collar stand to measure 1-5/16" at rear and band to be interlined with "Crease-N- Tack FREEDOM COLLAR FEATURE: Material consisting of self-goods and lining material forming the neckband and the collar must be arranged with the weave thereof on a bias so that it is stretchable in the direction parallel to the circumferential direction of the collar. This expandable collar will allow for slight variations in neck size and make it easier to button because of the stretch or yield of the material. UPPER FRONT: Each upper front shall have a full facing. The left front shall have a top center placket 1-1/2" wide with two double rows of stitching. Stitching on top center is not to be visible on the turn-back facing. The shirt will have 3 buttons and buttonholes on the upper front; spacing between each will be 3-¾" except the spacing between the neck button and the first button on the front, which will be approximately 2-1/2". Top center placket to have woven fusible interlining. Non-woven interlining unacceptable and shall be cause for rejection. The fronts shall be joined to the yoke so that both raw edges of the yoke are turned under, with the front sandwiched between, and then all three are stitched down with a 1/16" raised stitch. Safety stitch joining unacceptable. Back yoke to be 2-ply lined with shirt material. LOWER BODY, SIDE PANELS AND UNDERARM GUSSETS: Lower body, side panels and underarm gussets are made from 37.5™ Polyester fabric for ease of movement and comfort when worn under the AeroShell Carrier. SLEEVES: Sleeves are to be straight and whole and to have a ¾” hem and to finish at a minimum of 9 ½” long from shoulder seam.