This project will consist of removal and replacement of the building metal roofing and siding. 1. Demo existing steel roofing materials. Contractor shall remove fasteners from steel panels and stack on site for Owner to recycle. 2. Contractor shall be responsible for temporary covering for the duration of the project to prevent water intrusion during construction activities. 3. Inspect existing roof purlins. Replace any purlins that are cracked or damaged. Install additional purlins where needed to create mounting substrate for OSB sheathing. Provide allowance of $5,000.00 for any framing repairs that may be needed. 4. Install new ½” OSB roof sheathing over entire roof area. 5. Install Hi-Temp self-adhering roofing membrane over entire roof area. Metal Sales ms-HT. 6. Install new metal roofing. Metal Sales Classic Rib, 26 ga. Exposed fastener system. Install new roof jacks, flashings, closure strips and boots as needed. Install continuous ridge vent. Provide and install 3 bath fan roof caps and connect to loose ducts in attic. 7. Demo all existing fascia and soffit panels. 8. Ensure all ventilation chutes are in place. Adjust as needed for proper ventilation air flow. 9. Install new metal fascia, vented soffit panels (Metal Sales Lanced Flat), F & J channel as needed to integrate with the new roofing and siding products. 10.Demo all existing steel siding and brick wainscot materials and steel angle ledgers exposing the post frame wall construction. Remove all building accessories as needed (lights, dish mounts, etc.) Protect from damage. Contractor shall remove fasteners from steel panels and stack on site for Owner to recycle. Bid Alternate #1: Framing / Insulation Repair Allowance Hourly Labor Rate. Bid Alternate #2: Steel Roofing: Added lump sum cost to upgrade base bid roofing material to Metal Sales Vertical Seam – Striated 26 ga. 16” panel coverage concealed-fastener roofing system.
