The vehicles, equipment and accessories shall be new and ready for immediate use upon delivery, all service and make-ready having been done prior to delivery. Any vehicle not in such condition will be rejected. All vehicles are to be delivered to the Ocean County Department of Vehicle Services, Chestnut Street, Toms River, New Jersey. 12. No advertising shall appear on any vehicle delivered under the terms of the contract. Further, the contractor will not affix the dealer name to the vehicle. Vehicles delivered to final destinations with dealer's advertising will be rejected. 13. No Vehicle will be accepted at the final delivery point without all supporting documentation and paperwork completed and delivered with the units, which include the vehicle title, warranty, odometer/engine hour statement (if applicable), specified manuals, any line set tickets, invoice and keys sets. No unit will be considered accepted until it has undergone final inspection. 14. All delivered vehicles must be clean both inside and outside. Manufacturer’s standard items, such as hubcaps, floor mats, jack and lug wrench or the like, shall be provided, installed, by the contractor prior to delivery. 9. Upfitting for Certain Motor Vehicle Bids VEHICLE UPFITTING: PRE-BUILD • A detailed vehicle production plan must be provided and approved prior to the start of any upfitting. The production plan detail must include exact mounting locations and configurations for all components. INSTALLATION • All vehicle upfits in the same class (i.e.: Patrol Package Interceptor) must be exactly the same throughout the fleet. Different class vehicles shall be done in the same capacity. This will allow for ease of use for operators when switching vehicles, as well as any maintenance, service or vehicle repurposing. If the vehicle type is already in service, the bidder must match the setup as close as possible to the existing vehicles. • All single wires must be function labeled every 4 inches. • All Wire connections must be soldered. • Pass-through holes in the vehicle must be sealed with RTV Sealer. • At any wire pass through a snap grommet must be installed. • A minimum of two spare independently fused power, ground and ignition leads to be terminated in the console as well as the electronics area. • Two spare data control leads, minimum of 10 amps each, are to be in the console area as well as the electronics area...
