1. Stack Chair – 18” - Ergonomic soft plastic chair with tubular steel frame with upper back and lumbar support and side-to-side flexibility. The legs are 1-1/8 inch 18- gauge tubular steel and feature a full nickel chrome frame with felt-base tips. Eighteen-inch seat height Mfg: Classroom Select Contemporary Chair; or approved equal. 2. Stool (Adjustable Height) – Frame: Heavy 1 1/8” 16-gauge steel tubing legs swaged to 5/8”. For maximum support and unit integrity, legs are MIG welded to an extraheavy-duty 11-gauge flat 8 ½” square, steel mounting plate positioned under the seat. A 16-gauge tubular-steel foot-ring, positioned for comfort and stability, surround the legs for additional strength. All parts have a bright nickel-chromed finish. Seat: 12 ¾” diameter, 5/8” thick Melamine Resin solid-plastic attached with four self-tapping screws through the steel mounting plate and into the underside of the solid-plastic. There is no exposed hardware on the seating surface. Glides: Four adjustable one-inch minimum diameter hard-carbon-steel chrome-plated rubber cushioned silent swivels – nylon base type with a flat bottom. Heights: Adjustable Heights from 18” to 30”. Mfg., Scholar Craft 300 series, Virco 120 or approved equal. 3. Student Open Front with Clear Wire Basket – Adjustable height – Solid, molded, thermosetting plastic, 18” x 24” x 25” - 30” adjustable height. Top shall be supported by a 1” O.D. by 16-guage non-swaged steel tubing with ¾” O.D. by 16- gauge U-shaped lower brace welded to the legs. Frame shall be chrome plated after all welding processes is complete. Unit shall be furnished with 21”W x 11”D x 5”H ¼” solid wire rod book basket and swivel nylon glides. Mfg.: Virco #72BRLBM, Scholar Craft #2400, or approved equal. 4. Folding Utility Table – 30” x 72” – Activity tables to have adjustable legs, height 22” to 30” in l” increments. Folding table should feature a ¾” particleboard core with a melamine laminate top, vinyl edge banding, center brace for added support. Mfg.: Allied #123072 or approved equal. 5. Entry Mats – 4’ x 8’ – 100% continuous filament polyester. Deep cut fluff pile with 1/8” vinyl backing, which extends 1” on each longitudinal side. Mfg.: Wearwell #211 or approved equal.
