Specifications include, but are not limited to: Hydraulic Guardrail Post Driver/Puller: Flat Bed: Shall be constructed of 4 inch x 7 1/4 pound per foot channel beam, 4-inch channel cross-members, 4- inch channel side rails, corner lights, reflectors, and mud flaps. The bed shall have two (2) toolboxes mounted ahead of the rear axles of the truck, one (1) on each side. Comply Yes/No: ____________________ Turn Table: Shall be a 5-inch-wide flange beam by 90 inches in diameter. The slide frame shall be equipped with a heavy-duty Nylatron or similar wear plate for the driver frame to slide on. The turntable will be driven by a hydraulic motor, giving 240 degrees of rotation. Turntable diameter (inches): ____________________Turntable rotation (degrees): ____________________ Comply Yes/No: ____________________ Frame Assembly: Drive frame will be constructed of a 6-inch box beam. Rail assembly will be a 4-inch I-beam with heavy-duty journal-bearing loops. Inside of the rail beam will be used to guide drop hammer and anvil. The overall height of the rail and boom assembly will be a maximum of 15 feet 8 inches. Rail and boom assembly overall height (feet): _________________________ Comply Yes/No: ____________________ Travel: The Post Driver/Puller component will extend 36 inches from the outside of the main unit (Driver/Puller) and then retract back to the original position. This travel will be 30 inches to 66 inches from the truck body. Travel (inches): _________________________ Comply Yes/No: ____________________ Auxiliary Engine: The Driver/Puller will have a 4.5L Tier 4 Final emissions-rated industrial engine rated for 74 horsepower. The engine will include an electric fuel pump from the chassis fuel tank. Engine to have a 12-volt electrical system with starter and flywheel alternator. Make: ______________________________________ Model: _______________________________________ Displacement (liters): ___________________________ Power (horsepower): ___________________________ Comply Yes/No: ____________________