Specifications include, but are not limited to: Encore SH laminator equipped with the following: (2) - Heavy-duty 1/4” painted steel side frames. (1) - 6.0” diameter x 64.0” roll face (web driven) top laminating roll covered with 50 Shore “A” Durometer silicone covering and equipped with internal electric heat and controls from ambient to 320º F. (1) - 6.0” diameter x 64.0” roll face (driven) bottom laminating roll covered with 70 Shore “A” Durometer silicone covering. (2) - Cantilevered unwind assemblies (one lower front and one upper rear) with manually adjusted mechanical brake assemblies for tension control, standard core chucks for 3.0” ID cores and electronic feed-back for repeatable tension control (RTS). (2) - Rewind assembly (top front, lower rear) with manually adjusted mechanical clutch for tension control standard core chucks for 3.0” ID core (1) - Pneumatically controlled nip assembly with a 1.19” nominal opening and “Dial In” spacer system. (1) - Top operator control panel assembly with forward/reverse, run/stop, heated roller and speed controls. (1) - Remote foot operated jog switch. (1) - Emitter/receiver nip protection circuits. (1) - Removable front infeed table (1) - Rear outfeed table. (4) - “E”-stop emergency function switches. (1) - Safety tape switch emergency-stop switches. (4) - Swivel casters and four (4) leveling bolts.