Specifications include, but are not limited to: 1. Removing and replacing thirty (32) courtroom pew/benches in Courtrooms 1 and 2. a. Courtrooms 1 and 2 shall have a Cantilever pew/bench end style and will match the existing colors. b. Furnishing supplementary and miscellaneous items including, but not limited to, anchorage, braces, fasteners, and devices incidental to or necessary for a sound and secure installation. c. Achieving a layout of the benches that conforms to ADA regulations and maximizes the seating capacity. 2. Bench counts and approximate sizes for each Courtroom are as follows: a. Courtroom 1: Fourteen (14)-12’ (benches), two (2)-9’ b. Courtroom 2: Fourteen (14)-12’ (benches), two (2)-9’ 3. Materials a. Bench shall have a solid wood back and seat with wood supports; end panels with solid caps. Benches shall meet the Test Method for Surface Burning Characteristics of Building Materials ASTM E84. (1) Fabricate per approved shop drawings. (2) Adhesives: Type II (moisture resistant). (3) Back: Flat full height style. Solid wood with a solid wood cap rail. (4) Seat: Contoured style. Solid wood with a solid wood edge band and seat rail. (5) Supports: solid with solid wood base and front/back edge bands. (6) End Panels: Custom Design. Solid wood sides and solid wood edge bands and solid wood caps. (7) All exposed wood: i Type: Oak ii Cut: Flat Cut iii Solid Wood: Premium 1 (8) Continuous length benches over 18 ft in length must be joined with fully concealed locking mechanical connector with spline or dowel joint alignment. (9) Mechanically fasten to floor with concealed fasteners at each support panel. (10) Particle board components will not be accepted...
