Specifications include, but are not limited to: S800 Standard Diesel Engine Controller with the following features: • 24 VDC, Diesel, single engine controller housed in a wall mountable 30x24x10 inches enclosure with a hinged and gasketed door • Enclosure rated NEMA 4 • E-Stop • MAN-OFF-AUTO selector switch • MAN-PRESET-AUTO throttle control selector • TATTLETALE® • pilot LEDs • 7“ touch screen HMI • Safety shutdowns: o LOP o HWT o Manifold Vacuum o H/L engine oil level o low gearhead oil pressure o H/L gearhead oil level o high gearhead oil temp o LCL o vibration o high cat temp o H/L discharge pressure o low suction pressure o overspeed o overcrank o loss of speed o throttle failure. • Basic engine automatic control features: o throttle rate of increase/decrease o cycle cranking o warmup/cooldown o delay on start/stop.; S800 Standard Lift Station Central Controller with the following features: • 24 VDC • central controller to control up to (10) ten equal-sized engine driven pumps and up to (3) three electric motor driven pumps • housed in a wall mountable 30x24x10 inches enclosure with a hinged and gasketed door • Enclosure rated NEMA 4 • Status/Alarm LEDs • 15” touch screen HMI pre wired and mounted on enclosure door. • Central controller is pre-programmed to monitor wet well level and stage pumps on/off to maintain level set point. • Auto/Manual alternation of starting position of each pump • Emergency Operation for loss of transducer • high-high float switch, or loss communication. • SCADA ready via Modbus TCP/IP and data logging.