Specifications include, but are not limited to: 1. Trailer Design & Construction 1.1. General Description 1.1.1. The trailer shall be a heavy‐duty, quarter frame end dump type, designed for supplying hot mix asphalt to a road paver. 1.1.2. Complete with all standard features and accessories provided by the manufacturer plus all additional options and accessories specified 1.1.3. Must meet all applicable FMVSS, DOT, and ICC Requirement 1.1.4. Dump bed and quarter frame shall be steel. Comply: ____Yes ____No 1.2. Construction 1.2.1. Dump bed body to be elliptical shape 1.2.2. Dump bed capacity 26 cubic Yards 1.2.3. Dump bed Front Body panels and Side panels to be constructed of 1/8”AR450 Steel 1.2.4. Dump Bed Rear Body panels to be constructed of 3/16” AR450 Steel 1.2.5. Front wall of dump bed not to exceed 18 “ above side wall height 1.2.6. Side walls to be 42” in height above floor of dump bed 1.2.7. Overall length of entire dump trailer not to exceed 32’ 1.2.8. Highest point of trailer not to exceed 11’ 5” with trailer parallel to the ground 1.2.9. Kingpin plate to ground when trailer is level to be 46”– 50” 1.2.10. Dump bed top rail to be constructed with 4” x 4” X 3/16” Hi‐Tensile Tubing 1.2.11. Dual Longitudinal steel beams full length of dump bed 1.2.12. One(1) Steel Side Brace per side 1.2.13. Center of Kingpin to center of rear axle not to exceed 29’ 1.2.14. Steel Ladder at front with 2 steps Inside 1.2.15. ICC Removable Bumper 1.2.16. Roll‐Rite Electric Side Roll Vinyl Tarp Comply: ____Yes ____No 1.3. Tailgate 1.3.1. Tailgate to be constructed of aluminum with a minimum opening of 81” 1.3.2. Tailgate to be mounted over hung 1.3.3. Tailgate to be Air‐Lift operated 1.3.4. Tailgate to be controlled in tractor/truck cab 1.3.5. Mud Flaps attached to tailgate Comply: ____Yes ____No 1.4. Hoist Box and Cylinder 1.4.1. Hoist cylinder to be a minimum of 8” diameter 1.4.2. Hoist cylinder to be mounted inverted 1.4.3. Hoist cylinder to be mounted external of dump bed Comply: ____Yes ____No 1.5. Chassis 1.5.1. Chassis to be semi‐frameless design 1.5.2. Longitudinals to be 4” X 8” X 3/16” 1.5.3. Arms to be 3/16” fabricated tubing 1.5.4. Stabilizer to be 3” X 4” X 1/4” 1.5.5. Landing gear shall be 2 speed capable of supporting trailer loaded to maximum capacity 1.5.6. King Pin to be ¼” AR450 (Rocking/Breakaway)