Specifications include, but are not limited to: A Service - 5 Months/5,000 Miles. 1. ___INSTRUMENTS AND CONTROLS – Check all instruments, gauges, switches, controls and warning devices. 2. ___LIGHTS AND HORN – Inspect all lights, signals. 3. ___SEAT BELTS – Check fabric and buckles. 4.___BRAKE AND CLUTCH – Test to determine if both function properly, check pedal free travel. 5. ___GLASS – Check for damage/accident. 6.___BODY CONDITION – Rust/damage that will affect operation. 7.___WINDSHIELD WIPERS AND BLADE – Check for serviceability. 8.___LIGHT LENSES – REFLECTORS – Broken or damaged 9. ___STEERING AND SUSPENSION – Check for free play. 10. ___LEAKS—Visually inspect engine compartment, gear housings, backing plates, for water, fluid, oil or oil leaks 11. ___EXHAUST SYSTEM—Inspect muffler, exhaust and tail pipe and all connections for leaks. 12. ___SHOCK ABSORBERS – Check for looseness 13. ___DRIVE LINE UNITS – Engine mounts, transmission mounts, transfer case mounts, PTO mounting, clutch housing, drive shafts, U-joints, differential(s) 14. ___WHEELS AND TIRES – Wheel lugs for tightness, tires for damage and wear, rotate if required by wear, check tire air pressure 15. ___CHASIS – Service all fittings, oil all control linkage 16. ___BODY – Lubricate all door and deck hinges, Striker plates and Latches. 17. ___HEAT CONTROL VALVE – Oil check operation 18. ___ENGINE – Change oil and oil filter ___________ Qts. 19. ___TRANSMISSION MANUAL – Check fluid level 20. ___GEAR HOUSINGS – Check fluid level _____________Pts. 21. ___ DIFFERENTIAL(S) – Check fluid level 22. ___WINDSHIELD WASHER -- Check fluid level 23. ___AIR CLEANER – Remove and clean 24. ___BATTERY – Check fluid level, cables, and terminals 25. ___HOSES AND DRIVE BELTS __ Check serviceability and tension 26. ___COMPRESSOR/AIR CONDITIONER – Run unit, observe Freon level at sight port 27. ___RADIATOR – Check coolant level 28. ___BRAKE MASTER CYLINDER – Check fluid level 29. ___POWER STEERING – Check fluid level 30. ___TRANSMISSION/AUTOMATIC – Check fluid level __________Qts 31. ___REPLACE PM service indicator in folder. B Service – To be completed after 2 – A services or 15,000 Miles 1. ___INSTRUMENTS AND CONTROLS – Check all instruments, gauges, switches, controls and warning devices. 2. ___LIGHTS AND HORN – Inspect all lights, signals. 3. ___SEAT BELTS – Check fabric and buckles. 4.___BRAKE AND CLUTCH – Test to determine if both function properly, check pedal free travel. 5. ___GLASS – Check for damage/accident. 6.___BODY CONDITION – Rust/damage that will affect operation. Check body and door drain holes 7.___WINDSHIELD WIPERS AND BLADES – Check for serviceability. 8.___LIGHT LENSES/REFLECTORS – Broken or damaged 9.___ STATE SAFETY INSPECTION -- Complete 10. ___STEERING AND SUSPENSION – Check for free play.