Specifications include, but are not limited to: The Vendor will be responsible for manufacturing and delivering to the Office of Technology Services (OTS), Production Support Services (PSS) the 2025 IFTA decals. The decals shall be manufactured in sets of two per liner and serialized such that each decal in a set will have duplicate serial numbers; however, each set shall be consecutively and uniquely numbered. Application instructions will be printed on the back of the liner. Additionally, the decals must meet all of the following specifications. Inadequate facilities to comply with all of the following specifications and provisions will constitute grounds for rejection of bid. Quantity: 50,000 sets of 100,000 individual decals (two duplicate decals per set). Decal Size: 3" x 3" (overall size 6" x 3" for two duplicate decals side-by-side on one liner). Material: Reflective material that has a counterfeit-deterrent mark integral in the sheeting, making unauthorized reproduction extremely difficult, is required. The marks should be visible during daylight, but disappear by reflected light at night. The day and night color of the sheeting are similar and they will remain highly reflective when viewed at wide entrance angles. The decals must be destructible when an attempt is made to remove them. This material must fracture if tampered with, making it impossible to remove in one piece for reapplication. The decals cannot be removed without showing evidence of tampering. The decals must have a counterfeit and official use only mark embedded for instant identification to make it virtually impossible to be replicated or forged. Specifically, the decal must have a security "void" feature where any attempt to remove the decal, once applied, will result in its destruction or will cause the word "VOID" to appear, thereby preventing its reuse...