Specifications include, but are not limited to: • The Contractor shall be solely responsible for handling and disposing of any materials that it deems acceptable for refuse, recycling, and wet waste according to industry approved standards. • Provide policies on non-conforming waste products, i.e., any waste product in the dumpster not allowed in the waste handling facility and explain how this waste would be handled. • Size of containers and a schedule of pick-up shall be determined by mutual agreement between the end user agency representative and the contractor. Page 20 of 33 • The agency reserves the right to add or delete containers and / or change frequency and schedule of pick-ups. User agencies will be responsible for notifying the vendor one week in advance of addition and deletion of containers. • Contractor agrees to furnish adequate personnel and equipment to provide trash container(s) and pickup service. • Due care must be exercised to prevent scattering of waste on grounds and pick-up area must always be kept clean. No loose papers, debris or other material shall be left around the pick-up site or allowed to blow while dumping operation is in progress. Areas in close proximity (approximately 10’ x 10’) to the pick-up site shall be deemed Contractor’s responsibility. The Contractor shall ensure lids on containers are in good working order and closed after pick-ups. Haul containers shall be tied or enclosed so that leaking, spilling, or blowing are prevented. The Contractor will be fully and solely responsible for any consequential cleanup(s). Complaints regarding service will be corrected within 24 hours of notification.
