Specifications include, but are not limited to: 1. One (1) skid-mounted 1.5-meter belt filter press complete with motors, drives, control panels, belt conveyors, a wash water booster pump, and auxiliary Equipment to dewater waste activated sludge at the Frank Satterfield Road Water Pollution Control Plant. B. The equipment manufacturer shall furnish: 1. One (1) complete belt filter press system that will control the belt filter press, feed pumps, belt conveyor(s), and emulsion polymer feed system (provided by others). C. The Equipment will be located in an enclosed, heated, ventilated, and wet area as indicated. Construction materials shall be as specified and as required for corrosion resistance. D. Contractor shall furnish all Equipment complete with all components, hardware, motors, controls, and all other parts and accessories as indicated, specified, or required for proper installation, operation, and maintenance. E. All Equipment specified in this Section shall be fabricated, assembled, and tested in full conformity with Drawings, Specifications, engineering data, instructions, and recommendations of the equipment manufacturer unless exceptions are noted by the Engineer. All belt filter press components shall be provided by the same manufacturer and shall be suitable for installation. Any revisions necessary to accommodate the Equipment furnished shall be the responsibility of the Contractor. 1. Complete manufacturer’s data, specifications, and detailed drawings for all Equipment and materials which shall include complete descriptive data to define materials, sizes, capacities, types, models, accessories, etc. Drawings and other information shall be suitable for erection and installation of Equipment and materials. 8. Electrical schematic control diagrams, wiring diagrams, and process and instrumentation diagrams (P&ID). All diagrams shall be complete and have uniquely numbered terminals, wires, and devices.