Specifications include, but are not limited to: a. Acceptable Boat and Motor Model: One (1) G3 Gator Jon 16DK. Shall include the following: 1. Boat dimension: Length 16’5” and bottom width shall be 48” 2. 100 Gauge shall be all welded Aluminum Hull 3. 20” Transom Tiller Steer with tilt and trim, Seat Base in Front Deck 4. Beam shall be 69” 5. Navigation Lights, Bilge pump, Side Storage 6. Fuel tank shall be 6-gallon portable tank, and Bow wired for Trolling Motor 7. The motor Shall be Yamaha F40LA 8. Outboard motors shall be supplied and installed by the Contractor; the Contractor shall provide and install all controls. Motor controls and gauges shall be the same brand as the motors. Fuel filter/water separator of canister style matched to the motors and of the same brand as the motors provided. Filter shall be readily accessible for servicing. 9. The motors and all controls and features shall be tested, and the boat delivered in a ready-to-run condition. b. Acceptable Boat and Motor Model: One (1) G3 Gator Jon 17CCJ. Shall include the following: 1. Boat dimension: Length 17’1” and bottom width shall be 56” 2. 100 Gauge shall be all welded Aluminum Hull 3. 29” Transom Center Console, Front Storage, 2 Flip seat with Livewell 4. Beam shall be 82” 5. Navigation Lights, Bilge pump, Aerated Livewell 6. Built In 14 Gallon Fuel Tank, Two Seat Bases, and Bow wired for Trolling Motor 7. The motor Shall be Yamaha F90JB 8. Outboard motors shall be supplied and installed by the Contractor; the Contractor shall provide and install all controls. Motor controls and gauges shall be the same brand as the motors. Fuel filter/water separator of canister style matched to the motors and of the same brand as the motors provided. Filter shall be readily accessible for servicing. 9. The motors and all controls and features shall be tested, and the boat delivered in a ready-to-run condition. c. Acceptable Boat and Motor Model: One (1) G3 Gator Jon 17SC. Shall include the following: 1. Boat dimension: Length 17’2” and bottom width shall be 56” 2. 100 Gauge shall be all welded Aluminum Hull 3. 20” Transom Side Console, Front Storage, 2 Flip down seats 4. Beam shall be 83” 5. Navigation Lights, Bilge pump, Aerated Livewell 6. Built In 19 Gallon Fuel Tank, Two Seat Bases, and Bow wired for Trolling Motor 7. The motor Shall be Yamaha F70LA 8. Outboard motors shall be supplied and installed by the Contractor; the Contractor shall provide and install all controls. Motor controls and gauges shall be the same brand as the motors. Fuel filter/water separator of canister style matched to the motors and of the same brand as the motors provided. Filter shall be readily accessible for servicing. 9. The motors and all controls and features shall be tested, and the boat delivered in a ready-to-run condition.
