Specifications include, but are not limited to: Material Requirements – WATER MAIN FITTINGS AND ACCESSORIES: − AWWA C110-Latest Edition, Class 250 cast iron mechanical joint pipe fittings, cement lined, all bells, with accessories, entire fittings tarred. − Ductile iron fittings meeting above C110 specifications are acceptable. − Gaskets shall be armor-tipped conductive M.J. (no lead). − Bolts shall be Baked-on ceramic-filled flourocarbon resin. − Flanges, gaskets, bolts and nuts shall be furnished in individually packaged kits, except 6” and 8” fittings shall be furnished with gaskets, bolts, and nuts only (no flanges). − Bolts shall be manufactured from corrosion-resistant, high-strength, low-alloy steel in accordance with ANSI/AWWA C111/A21.11, that has a baked-on ceramic-filled fluorocarbon resin, which handles the needs of highly corrosive conditions. − Conductivity copper straps, 1.5” X 36” with pre-drilled bolt holes (0.812”) at each end. Capable of handling 500 amps. Or equal. − Polyethylene Encasement Requirements: V-Bio Enhanced Polyethylene Encasement, or Engineer approved equivalent. − Friction Clamps (Socket Clamps) − Grip Rings Restraint; Acceptable manufacturers: − U.S. Pipe & Foundry − Trumbull − Tyler Union − Griffin Pipe Products − J&E Earll Manufacturing (Conductivity straps) − Romac – Gripring Pipe Restraint; Material Requirements – RESTRAINED JOINT FLANGES: − Restrained Joint Flanges shall be compatible with Class 52 ductile iron pipe and AWWA C110 fittings. − Flanges shall be furnished with bolts, nuts and conductive (no lead) gaskets − Add nuts and bolts shall be supplied with baked-on ceramic fluorocarbon resin, or coated with at least 7-mil. fusion bonded epoxy...