Specifications include, but are not limited to: Vendor shall provide Agency with the Contract Items listed below on one-time basis. Contract Items must meet or exceed the mandatory requirements as shown below. Vendor must conform to the specifications shown on the attached diagram of the existing sinks and toilets. Twenty Stainless Steel Low Consumption Blowout Jet on floor Toilet or Equal 3.1.1.1 Toilet must be institutional grade Stainless Steel 3.1.1.2 Toilet must conform to American National Standards Institute A112.19.3 and CSA B45.4 complaint. 3.1.1.3 Must be fabricated from 14 gage, type 304 stainless steel and are seamless welded construction. Wall flange is structurally reinforced, exterior is satin finish, with integral contoured toilet seat. 3.1.1.4 Must be No accessible voids or crevices where contraband can be concealed. 3.1.1.5 Toilet must be a blowout jet type with Elongated Bowl. 3.1.1.6 Toilet requires a minimum of 25 PSI flow pressure and uses a minimum water consumption of 1.28 GPF. Toilet trap shall have a minimum 3-1/2” seal that shall pass a 2- 1/8” diameter ball and be fully enclosed. 3.1.1.7 Toilet must have a Water Inlet that is 3 inches outside diameter and is 12.75 inches from the floor. 3.1.1.8 Toilet must have a drain hole that is 6 inches outside diameter and is 4.25 inches from the floor...