Specifications include, but are not limited to: MODULE REMOVAL AND INSPECTION: • Complete module electrical and O2 system to be inspected for proper operation and customer advised of condition and action to be taken. • Disconnect all wiring, harness, hoses, cables, and mounting bolts from the chassis. Each will be labeled. • Removal of attendant seat, pedestal, floor trim, thresholds, antlers, lock bar, floor covering, plywood sub floor, and aluminum floor pan to gain access to the floor structural framework and module mounting points. • Remove module from chassis. • Exterior of module to be washed by hand and inspected for water leaks. NEW CHASSIS: • New 2023/2024 Ford F350/F450/550 cab and chassis remount or demo with ambulance prep package with diamond plate running boards to be installed. • New black grill/brush guard to be installed that will protect the grill and headlamps. The grill/brush guard is not compatible with a winch. • New center control console with two drink cap holders and two large map book holders. • The existing siren will be tested and reused. The customer will be notified if there are any performance issues with the siren. • Heat shield to be installed. • New Phoenix chrome wheel covers. • New rear window pass-thru. • New bellows, unigrip cab to module. • New heater hoses and A/C hoses to be installed. • New cables, terminals, under hood breakers, and wiring to be installed and/or extended as needed. Complete electrical check-out. • New fuel filler hose. • New module mounting isolators and grade #8 fasteners. • New battery disconnect switch. • New back up alarm. 4 EXTERIOR: • Exterior of module to have all lights, Perko vents, drip rails, kick plate, stone guards, fuel filler housing, skirt rails, shore line plate and step bumper removed. • All entrance and compartment doors are to be removed from the module and disassembled for painting. • All compartments to be cleaned and polished. Lower front right compartment will be lined with black bed liner material. • All compartment and module door gaskets to be replaced with new gaskets. • All module door panels to be clean and polished. • Module door windows are to be sealed and reinstalled. • Install new LED warning lights in place of existing warning lights. • Install new LED lights housing and gaskets installed on sides of the module. • The rear top bulkhead wall to have the existing lights reused. New lenses and gasket will be installed...