Eight (8) 75 Gallon L-Type UTV Fire Suppression Skid Units 3.1.1.1 75 gallon capacity “L” shaped low profile polypropylene water tank skid unit. The Tank shall be constructed of 1/2 inch black, textured, UV resistant polypropylene material with a 3/4-inch-thick tank floor and pump platform. It shall be baffled with minimum 3/8-inch transverse and longitudinal baffles to meet NFPA standards. 3.1.1.2 The Tank at a minimum shall include the following: White plastic sight gauge located on the driver side rear. Lo-profile 5-inch minimum diameter tank fill/vent. The driver’s side tank top shall have an additional 3/4-inch polypropylene mounting plate. 1 1/2- inch diameter FNPT fill port and 1 1/2-inch diameter and a 2 inch diameter FNPT drain. Must have front and rear mounting tabs. 3.1.1.3 Pump must be Wick 100-4M single stage 4 stroke pressure pump, or equivalent, with minimum 2.0hp engine with max weight of 20 lbs. Pump must be single stage, high pressure driven via a centrifugal clutch. 3.1.1.4 Hose reel must be a rust-free stainless-steel drum/nylon A frame mounted directly behind the driver to not impede visibly with a 3/4-inch GHT male riser. 3.1.1.5 Hose reel must have a minimum of 100 feet of 3/4 inch lightweight hose with field repairable GHT couplings. 3.1.1.6 All valves must be full port quarter turn brass ball valves rated at 600 PSI. All plumbing must be stainless steel and rated at 150 PSI minimum. 3.1.1.7 Discharge side of the pump shall be plumbed, via high pressure hose to eliminate vibration, to only 100% stainless steel piping. Must contain a preset pressure relief valve and a 160 PSI stainless steel pressure gauge.