Specifications include, but are not limited to: The intent of this project is to provide and install a new high resolution NDAA compliant CCTV system that meets the following specifications and minimum equipment requirements. Equipment: 1. 33 indoor IP cameras. Cameras must be NDAA compliant and have a minimum resolution of 4MP, 2.8mm fixed lens or variable zoom, 120dB Wide Dynamic Range, on board micro SD card slot and IP67 protection or greater. 2. 21 outdoor IP cameras. Cameras must be NDAA compliant and have a minimum resolution of 5MP, 180 degree lens if fixed or variable zoom, 120dB Wide Dynamic Range, on board micro SD card slot, IK10 vandal resistance, IP 67 protection or greater. Camera must have 24 hour all light color imaging capabilities. All outdoor cameras will be installed with factory authorized mounting hardware in a professional manner. No exposed cables of any kind. 3. 4 (four) new CCTV Servers or NVR’s located in the 4 server rooms/areas. Each Server/NVR will contain no less than 12TB of CCTV Grade HDD each. 4. 3 (three) new 6u minimum, glass front, swing open, lockable, wall mounted network racks will be installed into the facility to house new CCTV servers and UPS’s. There is 1 existing server rack in place making 4 server rooms in total. 5. Three new smart rack mountable UPS will be provided (one in each rack) with a 500va minimum rating. There is 1 existing UPS in place making 4 UPS in total. System wiring and installation: 1. A new network drop will be installed for each camera and CCTV server rack location (55 total) using Cat6 E full copper (no cca) cable 2. All new network drops will be field terminated and tested using high quality RJ45 connections. 3. All cables will be concealed above drop ceiling or in conduit/raceway as is common in the area of installation. No cables will be exposed in any area. 4. All cables will be installed in a code compliant manner as outlined in the NFPA 70. The implementation of J-Hooks, trays, conduits, junction boxes and fasteners will be required per code with j-hook spacing no more than 48” and no less than the minimum cable bend radius requirements of the selected cat6 cable. 5. All cables and conduit rough in required will be provided by the installer.
