Specifications include, but are not limited to: 1. Membrane Waterproofing System: Bids are solicited for furnishing and delivering the various materials in accordance with NYSDOT specifications as listed below and shall be listed on the NYSDOT Approved Materials List. The membrane waterproofing system shall consist of one of the proprietary sheet systems. No substitutions of the proprietary portions of the applied system shall be allowed. Specifications shall be per NYS Department of Transportation Technical Service Materials approved list for concrete waterproofing membranes; sheet-applied waterproofing section 717-0201. The membrane waterproofing system shall include a membrane that is constructed of a prefabricated peel and stick reinforced laminate. The release film used on the membrane shall be specifically designed to facilitate removal without tears or splits in the membrane. The membrane system shall be equivalent to the Royston 10-A Membrane system and shall consist of Royston Bridge Membrane No. 10-A, Royston Bridge Membrane Primer 713-A; and Royston 104 CM Caulkable Mastic; all as manufactured by Royston Laboratories, Inc., Pittsburgh, Pennsylvania. Membrane system must be for use on existing bridge decks, as well as, new construction. The maximum width that Franklin County needs is 48” wide. 2. Synthetic Bond Breaker: The synthetic bond breaker shall conform to the requirements of those contained in the NYSDOT Specification Section 728-06. 3. Type D Waterstop: The Type D Waterstop shall conform to the requirements of those contained in the NYSDOT Specification Section 705-11 and referenced on the NYSDOT Bridge Detail Sheet BD-MS3E...