1 - HVAC Replacement (Specification ID:0 Estimated Qty:0) Replace Central HVAC Unit - Replace Condensate Line - Replace Freon line: (The contractor shall inspect duct work that is accessible for any damages) Contractor shall replace existing central heat and air conditioning unit as follows, remove existing unit, supply and install new central heat and air conditioning unit per manufacturer's installation requirements, new unit shall be properly sized as determined by industry approved heat/loss, heat/gain calculation. This shall include coils, condenser with approved base, thermostat, control relay, and all required material for proper installation of new central heat and air conditioning unit. The contractor shall replace the condensate line. The contractor shall replace the freon line. Thermostat must be programmable and match the unit. The HVAC contractor shall be responsible for providing the installation of all electrical work and plumbing required to meet all City of Garland code requirements. Upon completion the contractor shall be required to test and properly balance the system, and guarantee the entire system against faulty materials and workmanship for a period of one year following completion and acceptance. All required green tags and manufacturers warranty papers shall be given to the Loan Processor upon completion of project USE: A 15 Seer unit (RHEEM, PAYNE, FRIGIDAIRE, TRANE or Carrier ONLY) NOTE: This item will require a City of Garland Mechanical Permit. Use a certified and licensed HVAC Contractor. A copy of the permit shall be given to the Rehab. Specialist prior to work start for verification of permit issuance. The Mechanical Contractor shall be responsible for any corrections if red tagged until a green tag is issued. All green tags are required upon completion of project. Final shall result in the proper HVAC installation per manufacturers installation requirements and shall meet all City of Garland code requirements. Priority: 2 Ceiling Quantity Units Total 2 - Repair Drywall (Ceiling) (Specification ID:0 Estimated Qty:0) Repair Ceiling Drywall The contractor shall cut a hole in the kitchen and laundry ceiling to determine a water leak. Contractor shall repair the ceiling drywall covering as follows, all replacement work shall consist of the removal of all fixtures and attached surface items not to be painted. Remove damaged designated sheetrock from stud to stud and replace with new sheetrock same thickness as adjacent areas. All new sheetrock shall be properly fasten so as to not sag or bow. Tape and bed all joints and float. Protect any items not removed so as to not get paint, mud or textured. Prep and paint corner to corner. Reinstall all removed items to drywall upon completion. Use: Sherwin Williams, Kelly Moore paint and local supplier for drywall materials. Final shall result in the replacement of new sheetrock to the designated area properly installed, taped and bedded, textured, and paint.
