Specifications include, but are not limited to: Contractor shall provide all labor, materials and equipment necessary to remove approximately 43 squares of existing roofing and underlayment, repair deteriorated decking and overhang material and trim, and shall install new laminated asphalt architecture shingle roofing at two separate buildings located at Elayn Hunt Correctional Center. All measurements listed are estimated, contractor shall verify all measurements in the field. Specifications: *The following specifications apply to both of the State Houses listed above. Contractor shall remove existing shingles, felt, drip edge, flashing, chimney base flashing, ridge vent shingles, and pipe boot with metal base. Contractor shall carefully remove shingles, any rotten or deteriorated roof decking, all felt, nails, vents, drip edge, jacks and any rotten or deteriorated building materials where necessary and applicable to this project. Contractor shall not damage any substrates or adjacent surfaces, if damaging occurs it shall be repaired or replaced to the satisfaction of the Project Manager (Keith Henderson DOC) at no additional cost to the State. Contractor shall be responsible for any required notifications, inspections, permits, labor, materials, disposal, transport, etc. to complete this project. The contractor shall completely remove ALL existing shingles, nails, flashing, etc., demolished as a result of this project, from the property and dispose of in a manner that meets ALL codes and regulations regarding disposal of such. Use tarps, as necessary, and utilize good methods to insure that NO existing old nails are lost on the property. Contractor shall protect all work sites (where current work is being performed) from public access at all times during the course of this project. Contractor shall provide a dumpster specifically for use during this project. Contractor shall replace rotting or deteriorated wood: Replace any rotten wood overhang. Replace any rotten or deteriorated roof decking. Replacement wood material shall be pressure treated. Contractor shall install replacement felt, shingles, drip edge, flashing, chimney base flashing, ridge vent shingles, and pipe boot with metal base.
