Specifications include, but are not limited to: GALVANIZED CHAIN LINK FENCE AND GATES Furnish all labor and materials necessary to complete all chain link fencing and gates indicated, specified or both. Comply with standards of the Chain Link Fencing Manufacturer's Institute for "Galvanized Steel Chain Link Fence Fabric" and "Industrial Steel Specifications for Fence Posts, Gates, and Accessories", and as herein specified. Provide each type of steel fence as a complete unit produced by a single manufacturer, including necessary erection accessories, fittings and fastenings. Products 1) Fabric - 9 galvanized (ga.) steel wires, 2" diamond mesh, tensile strength of 80,000 lbs. per inch with both top and bottom selvages knuckled. Width as indicated. 2) Framing and accessories a) End Posts: 3.0" O.D. steel pipe, 4.64 lbs. lin. ft. Domestic Schedule 40 b) Line Posts: 2.50" O.D. steel pipe, 3.117 lbs. lin. ft. Domestic Schedule 40 c) Top Rail: 1-5/8" O.D. x 20' long steel pipe. Provide means for attaching top rail to posts. d) Post Tops: Weather tight cap for tubular posts. Provide one cap for each post. e) Stretcher Bars: One-piece lengths, full height of fabric, 3/16" x 3/4", for gates and end posts. f) 6 ga. steel, Tension Wire shall be run at bottom of fabric. g) Stretcher Bar Bands: 15" O.C. to secure stretchers to posts. 3) Swinging gates 4) Furnish chain link gates as required. Construction: a) Gates shall be fenced with the same fabric used for the body of the fencing. Install with stretcher bars at vertical edges and the wires at top and bottom edges. b) Gate frame shall be 1.90" pipe with welded or riveted corners. Braces and truss rods shall be furnished when necessary to prevent sagging. c) Hinges shall be pressed steel or malleable iron. Provide one pair for each leaf. Latches shall be forked type for single gates and plunger bar types for double gates. Both shall have a padlock eye and permit operation from either side of gate. Keepers shall be provided for each gate leaf over 5' wide and shall consist of a mechanical device for securing the free end of the gate when in full open position. d) Gate Posts: Gate posts shall be of the following sizes for single swing gates or one leaf of double gates.
