Specifications include, but are not limited to: A. GENERAL It is the intent of this specification to describe the minimum requirements for close-nap nylon carpet-like Indoor Floor Entrance Mats (hereafter Mats). Read this document carefully. Check and/or acknowledge each bullet point to confirm that your product and services are compliant with these specifications. These specifications are not intended to be exclusionary but shall establish the minimum standards by which all items bid shall be compared. Firms submitting alternates must include any and all manufacturer descriptive literature. Failure to sign and submit this specification with your bid will result in bid rejection. B. SURFACE Smooth surfaced carpet-like with nosing Manufactured from 100% heat set, high density, high twist, synthetic yarns like poly propylene and nylon or a blend ½” Pile “dark” color, e.g., brown millennium, black lava, charcoal, gray or navy NOTE: Prior to award, the low bidder will be required to submit a color sample to the Department of AdministrationPurchasing Division for approval no later than seven (7) calendar days after receiving notification of award. Fade resistant Trap and hold moisture Scrapes debris from passing shoes Not cut down C. BACKING Non-skid rubber or vinyl Rubber cleated backing to minimize movement, curling, or waviness Lay flat without the use of tape, glue, or any other type of hold down device Foam or grippers to prevent “creeping” or “bunching” that are designated for areas that specify a walk off mat over carpet D. EDGE Four (4) sided nosing not to exceed 1-1/2 inch deep, smooth (flat) pattern E. SIZE To be in accordance with the sizes specified in Attachment A unless approved otherwise. F. STANDARDIZATION Meets or exceeds Federal Flammability Standard DOC FF 1-70
