Specifications include, but are not limited to: 1.1 Body shall be fiberglass/Composite with aluminum bulkhead. 1.2 Rolltop with latch in open & closed position painted matching color. 1.3 Total body length shall be a minimum of 108” inches. 1.4 Total body width shall be a minimum of 94” inches. 1.5 The body interior height shall be a minimum of 42” inches. 1.6 Floor width shall be a minimum of 54” inches. 1.7 Front corner of body shall have stainless steel or aluminum diamond plate to prevent road debris damage to body. Corners need to be rounded to prevent sharp edges. 1.8 Rear mud flaps 1.9 Compartments shall have flow through ventilation system with drain holes. 1.10 Manufacturer’s standard LED light system with adequate supports to wiring to prevent sagging wiring. Must conform to FMVSS-108 Standard. 1.11 All wiring to be enclosed by protective tubing with all connections to be either soldered with shrink tubing or enclosed in watertight junction boxes. 1.12 Each side pack model to be mounted separately to floor and substructure) in the event of damage, one can be removed and repaired or replacement). 1.13 Manufacturer’s standard step type bumper with recess and anti-skid surface, bolted securely to truck chassis frame. Minimum twelve 12” steel treadplate rear tail shelf extension. 1.14 Hitch shall be a class V, rated minimum 16,000 lbs. gross trailer weight, minimum 2 square receiver opening with 7-prong Round pin trailer plug-in (see Wire Diagram below). RV plugs will not be accepted. 1.15 Lights shall be LED and recessed mounted in shock resistant rubber grommets and loom protected wires. 1.16 Trailer plug shall be wiring by layout below (see diagram below)
