Specifications include, but are not limited to: 1. Fuel system: A. Check fuel level in fuel tank B. Check operation of day tank C. Check fuel gauge D. Check operation of fuel low level circuits E. Check for water in fuel tank and main tank and pump off if necessary F. Change fuel filters and check for leaks G. General inspection of all components 2. Lubricating system: A. Check for proper oil level and pressure B. Check engine for oil leaks C. Change crankcase oil and engine oil filters D. Take and analyze oil sample 3. Cooling system: A. Check coolant level and antifreeze protection and change filter (s) B. Check condition of hoses and fan belts C. Check radiator for obstructions and clean if necessary D. Check jacket water heaters for proper operation E. Check for coolant leaks F. Lube fan drive G. Add cooling system conditioner if needed H. Check and record operating temperature. Verify that operating temperature is in the correct parameters I. Externally check coils for cleanliness 4. Exhaust system: A. Check condition of exhaust system B. Check rain cap 5. Air intake system: A. Check air inlet piping for possible leaks B. Check air service indicator while engine is running C. Check air cleaner and change filter (s) D. Check turbocharger for bearing wear and leakage E. Check exhaust restriction 6. Control system: A. Check operation of all gauges and meters B. Check operation of all controls C. Check shutdown and pre-alarm system D. Check startup system E. Check annunciator panel 7. Engine electrical starting system: A. Clean batteries and cables B. Check for proper connections C. Add water to batteries to maintain electrolyte levels D. Check battery voltage E. Check for proper operation of battery charge 8. Generator: A. Check main circuit breaker for proper operation B. Check intake and exhaust areas for obstructions and clean if necessary C. Check voltage regulator for cleanliness D. Compare generator output voltage to commercial voltage 9. Automatic transfer switch: A. Check cubicles for cleanliness B. Check indicating lights C. Check for proper operation of transfer switch including proper sequence of times, if possible. 10. General: A. Check for unusual conditions such as deterioration, vibration, leakage, high surface temperature or noise B. Run generator under load if possible C. Record all readings and file with the facility administrator D. Notify facility administrator of recommendations for additional service and/or repair work
