Specifications include, but are not limited to: 1. Design, Construction, and Features 1.1. Power Source 1.1.1. Self-contained hydraulic power pack with a small gasoline engine, direct mount hydraulic pump, reservoir, and flow-control valve 1.1.2. Gasoline engine must have electric start 1.1.3. Power pack must be mounted to a removable platform Comply: ____Yes ____No 1.2. Conveyor Drive System 1.2.1. The conveyor should be driven by a roller/stator type hydraulic motor 1.2.2. The conveyor drive roller shall be coupled to the motor via chain and sprocket system 1.2.3. All drive components, i.e. sprockets, chains, etc., shall be completely shielded by a removable cover 1.2.3.1. Conveyor drive shall not be accessed without removal of drive cover 1.2.4. All conveyor rollers shall be held in place by external flange-type bearings. Each flange bearing shall have a grease fitting. NOTE: Bearings built into the hub of conveyor rollers are not acceptable. Comply: ____Yes ____No 1.3. Conveyor Feed 1.3.1. A manually operated hydraulic flow control valve shall be located on the hydraulic power pack to allow conveyor belt speed adjustment 1.3.2. The conveyor belt shall be capable of reversing in direction 1.3.2.1. Reversing should be accomplished by swapping the two motor hoses at their connection with the under-hopper junction via quick disconnect couplers or via manual reversing control valve 1.3.3. The drive motor hoses and the flow control-valve hoses shall connect at an easily accessed junction point below the lower center of the hopper. Quick disconnect couplers shall be installed on the junction end of the motor hoses. Comply: ____Yes ____No
