Specifications include, but are not limited to: Chain link Slide Gate - (1) cantilever slide gate, 24' opening, 6' height, with 2-1/2" top and bottom horizontals, 2" uprights, 1-5/8" diagonal bracing, 9-gauge chain link fabric, 2" chain link mesh, 3- strands of Class 1, 12.5-gauge barbed wire, 4" O.D. gate posts, nylon rollers, and cantilever receiver latch. Chain Link Fence - Install approximately 1267 LF of 6’ tall with galvanized chain link fence - with (3) strands of barbed wire, 12.5-gauge, 4-point barbs, max 5” o.c. - 9-gauge fabric with 2” chain link mesh - 3" WT/LG40 corner, end and pull posts. - 2" WT/LG40 weight line posts, - 1-5/8" diameter, 40-weight, top rail - 7-gauge bottom tension wire. - Line post to be on 10’ centers, all posts set in concrete - Tie in new fencing to existing chain link fence post using all new mechanical ties and new barbed wire as needed. - Selvages: Top and Bottom selvage twisted. - 1-24 LF 6’ Tall Swing gate - 1-40 LF 6’ Tall Swing Gate Access Controls - Shall be compatible with existing AIPHONE system and tie in. - (1) dual height gooseneck-stand with two access control pads with AI - IX-DV cameras - Minimum 18” diameter concrete pad, embedded 24” in the ground, for gooseneck stand - install a (120v or 240v) single phase circuit, from the nearest service panel in the facility to the gate operator with 1” fiberglass/HDPE or PVC conduit with pull string - install 1” fiberglass/HDPE or PVC conduit for data communication from existing AIPHONE master station IX-MV system to the access control pad/camera and operator with pull string - fully integrate the existing system with new components; test & verify proper operation of controls - (2) protective 6” steel pipe bollards, concrete filled, painted safety yellow, embedded 3’ in the ground in minimum 12’diameter hole with concrete. Shall extend 48” above grade and be plumb in all directions - Conduits shall be bored under any concrete or asphalt surfaces.
