Specifications include, but are not limited to: DEMO: 3) The contractor shall bid to demo the following: (wall/ceiling sheetrock, wall/ceiling insulation, interior trim, cabinets, duct pipe, and existing floor covering) of the interior of the apartment and to remove all debris and dispose of at an approved dump site. ELECTRIC: 4) The contractor shall bid to remove all switches, outlets and covers. 5) The contractor shall bid to install new ivory switches, outlets, ground fault outlets and covers The contractor shall bid to remove existing light fixtures and install with new. (Match existing light fixtures and install new light bulbs) HAVC / WATER HEATER: The contractor shall bid to remove Furnace, A-Coil and Duct system. Remove and replace furnace platform. The contractor shall bid to install new 80% (70,000 BTU) up-flow furnace and an - 410 A-Coil and condenser. (With triple wall flue to be installed) 2 ton The contractor shall bid to install new metal insulation plenum. The contractor shall bid to install new steel duct pipe with 3" vinyl wrap insulation. (Installed to Housing Rehab specifications) The contractor shall bid to install new heat & cool thermostat. (Match existing) The contractor shall bid to install a new filter grill. (Match existing size) The contractor shall bid to install new ceiling air register/grills. The contractor shall bid to install (2) fresh air ducts in fumace/water closet. (High & Low) The contractor shall bid to install a new 30 gallon natural gas water heater with new copper flex lines and flex gas line. (With triple wall flue to be installed) The contractor shall bid to install new washer box, valves, and dryer vent in laundry room. EXTERIOR: The contractor shall bid to remove/reinstall storm doors with new closers. The contractor shall bid to remove/install new 6 panel exterior doors, jamb and trim. (Match existing doors with double bore and exterior trim) The contractor shall bid to insulate exterior and parties walls at R-19. The contractor shall bid BLOWN- IN fiberglass attic insulation, CERTAIN-TEED, OWENS CORNING (or equal to) to R-38. The contractor shall bid to install 5/8" sheetrock on all ceilings. To be installed with 1 -1/4' drywall screws according to manufacturer's specification.
