Specifications include, but are not limited to: DEMO: 3) The contractor shall bid to demo the following: (wall/ceiling sheetrock, wall/ceiling insulation, interior trim, cabinets, duct pipe, and existing floor covering) of the interior of the apartment and to remove all debris and dispose of at an approved dump site. ELECTRIC: 4) The contractor shall bid to remove all switches, outlets and covers. 5) The contractor shall bid to install new ivory switches, outlets, ground fault outlets and covers 6) The contractor shall bid to remove existing light fixtures and install with new. (Match existing light fixtures and install new light bulbs) HAVC / WATER HEATER: 7) The contractor shall bid to remove Furnace, A-Coil and Duct system. Remove and replace furnace platform. 8) The contractor shall bid to install new 80% (70,000 BTU) up-flow furnace and an - 410 A-Coil and condenser. (With triple wall flue to be installed) 2 ton 9) The contractor shall bid to install new metal insulation plenum. 10) The contractor shall bid to install new steel duct pipe with 3" vinyl wrap insulation. (Installed to Housing Rehab specifications) 11) The contractor shall bid to install new heat & cool thermostat. (Match existing) 12) The contractor shall bid to install a new filter grill. (Match existing size) 13) The contractor shall bid to install new ceiling air register/grills. 14) The contractor shall bid to install (2) fresh air ducts in fumace/water closet. (High & Low) 15) The contractor shall bid to install a new 30 gallon natural gas water heater with new copper flex lines and flex gas line. (With triple wall flue to be installed) 16) The contractor shall bid to install new washer box, valves, and dryer vent in laundry room. EXTERIOR: 17) The contractor shall bid to remove/reinstall storm doors with new closers. 18) The contractor shall bid to remove/install new 6 panel exterior doors, jamb and trim. (Match existing doors with double bore and exterior trim) 19) The contractor shall bid to insulate exterior and parties walls at R-19. 20) The contractor shall bid BLOWN- IN fiberglass attic insulation, CERTAIN-TEED, OWENS CORNING (or equal to) to R-38. 21) The contractor shall bid to install 5/8" sheetrock on all ceilings. To be installed with 1 - 1/4' drywall screws according to manufacturer's specification. 22) The contractor shall bid to install 5/8" fire rock sheetrock. To be taped, bedded and painted in the mechanical closet before new equipment to be installed. The platform will be (2) 5/8" plywood with support legs. 23) The contractor shall bid to install 14" water board (sheetrock) in all bathrooms and behind the kitchen cabinet and laundry room. 24) The contractor shall bid to install 14" sheetrock on exterior walls, interior walls, and window casings. To be installed with 1" drywall screws according to manufacturer's specification. 25) The contractor shall bid to install sheetrock metal corners on outside corners and windows. 26) The contractor shall bid to tape/bed and finish all sheetrock (3 coats), with a medium knock down on ceiling and walls. 27) The contractor shall bid to paint all ceilings and walls with (1) coat primer paint and (2) coats of interior paint. (GLIDDEN PROMASTER GL-8050-1002 WHITE INTERIOR LATEX SEMI-GLOSS WALL AND TRIM PAINT). 28) The contractor shall bid to replace all interior wood doors units and install new (6) panel door units. These doors will be painted with (1) coat primer paint and (2) coats of interior paint. (GLIDDEN PROMASTER GL-8050-1002 WHITE INTERIOR LATEX SEMIGLOSS WALL AND TRIM PAINT). 29) The contractor shall bid to install 2-1/4" K-trim for door units and floor base trim. With (1) coat primer paint and (2) coats of interior paint and to be caulked to the floor. (25yr. white caulk) (GLIDDEN PROMASTER GL-8050-1002 WHITE INTERIOR LATEX SEMIGLOSS WALL AND TRIM PAINT). 30) The contractor shall bid to install #2 white pine closet shelves with 1 "x 4" cleat to be mounted on the walls, a metal closet rod and brackets to support closet shelves. Theses shelves will be painted with (1) coat primer paint and (2) coats of interior paint. (GLIDDEN PROMASTER GL-8050-1002 WHITE INTERIOR LATEX SEMI-GLOSS WALL AND TRIM PAINT).
