Specifications include, but are not limited to: provide all labor, materials, equipment, associated travel and lodging cost to remove demolition of existing Aerco condensing boiler units and replace with Aereco Benchmark BMK3000 or state approved equivalent. All boilers are located inside the Central Plant on the 2nd floor of the Support & Visitation building. Replacement of the existing boiler flues and connections to existing lines shall be provided as needed to accommodate new boiler units. Existing boilers are controlled by a Boiler Management System (BMS). New boilers shall integrate with existing BMS and building automated HVAC controls. Bidder proposal should provide detail on boiler location, flue and piping, pipe hangers and supports, project plan and work schedule. The project will deliver 10 new boilers and installs. • Contractor is responsible for demolition and disposal of all replaced boilers and appurtenances. • Contractor shall provide all design, planning and any infrastructure upgrades required for the installation of the new boilers. • Contractor shall install new boilers and all related system components, including but not limited to, piping, hangers, shields, insulation, jacketing, pumps, conduits, wiring, electrical connections, and control systems. • Contractor is responsible for all cutting, core drilling, patching, painting and cleaning. • Contractor is responsible for all water flow balancing associated with the boiler replacement to ensuring that the water flow rates are properly adjusted throughout the system to achieve optimal performance and efficiency of the new boiler. • Contractor shall provide start-up, commissioning, adjusting, testing and operator training by manufacturers representative. • Contractor shall provide O&M manuals, as-built drawings, and warranties. • Contractor shall maintain minimum 68-degree temperature in areas served by boilers being replaced. • Coordination of demolition and installation of new lines are contractor’s responsibility. • Provide 1 year warranty for parts and labor. Provide equipment manufacturer O&M.
