Specifications include, but are not limited to: Exterior: 1. Demo existing windows and replace with Spec Thermotech sliding vinyl windows that meet egress requirements. Adjust siding to fit new windows. Install j-channel and 2” white brick mould and caulk around perimeter. 2. Demo and replace damaged; or supply and install missing gutter and downspout components, including leaf guards. 3. Contractor shall clean out all gutters. 4. Demo front steps and deck down to the frame. Provide labor and materials to reconstruct with all new decking, handrails, spindles and stairs. 5. Demo and replace front storm door. Include chain kit. 6. Demo and replace both bath venting boots. Replace shingles as needed. Match existing. 7. Remove old furnace exhaust. Supply all sheathing, underlayment, ice & water and shingles to patch the opening after remove. Match existing. 8. Demo rear deck, steps and landing down to the frame. Make adjustment to level the deck (as it’s slightly sloping). Provide labor and materials to reconstruct with all new decking, handrails, spindles, ramp, stairs and overhead trellis. Do not attach trellis to house roof. Interior: 1. Patch and texture water damaged ceiling drywall and to cover hole in rear hallway closet ceiling left from removed furnace exhaust. Supply and install new attic insulation as needed to fill void and replace any wet insulation found. Include patching poly. Continue with primer and painting per interior work scope item #3. 2. Patch and texture water damaged interior ceiling drywall surfaces in rear hallway, pantry closet and hall bathroom. Supply and install new attic insulation to replace wet insulation found above the shower in the hall bathroom, as needed. Include patching poly. Continue with primer and painting per interior work scope item #3. 3. Prime and paint all interior ceiling drywall surfaces. All (new and existing) texturing to match as closely as possible. Prime all ceiling drywall with Zinsser mold killing primer. Repaint all drywall ceiling surfaces Dover White. When complete, all the paint and texturing is expected to look as uniform as possible. 4. Demo and replace all smoke detectors with spec combo smoke c/o detector to meet code compliance. 5. Provide and install all new window extension jambs and casing to match existing finishes. Include spray foam during installation. 6. Electrical: Include $3,500 allowance in base bid to complete electrical repairs found when investigating: rear bathroom outlet; hallway bath outlet and light fixture; SW bedroom outlet; and kitchen florescent overhead light. Include demo and replace of bathroom fixture and kitchen florescent light fixture with all new bulbs. New fixture to match as close to possible to existing.
