Specifications include, but are not limited to: 1. Basic Specifications a. Operating weight with quick connect coupler & bucket, no less than 33,000 pounds _____ _____ _____________ b. Must include 36” digging bucket & 60” ditching bucket _____ _____ _____________ c. Operating manual & parts manual must be included _____ _____ _____________ d. Must have service facility within 20 miles of Central Maintenance Shop _____ _____ _____________ e. Review camera _____ _____ _____________ f. Quick connect coupler for attachment w/ lifting eye _____ _____ _____________ g. Must have hydraulic thumb, no wider than bucket _____ _____ _____________ h. Must be reduced tail swing machine _____ _____ _____________ 2. Engine a. Engine net power, no less than 100 HP _____ _____ _____________ b. Engine to be Tier IV final and meet 2024 emission standards _____ _____ _____________ c. Must have auto idle to reduce fuel consumption, when not in use _____ _____ _____________ d. Automatic regeneration _____ _____ _____________ e. Automatic engine shutdown protection against loss of oil pressure/coolant _____ _____ _____________ f. Electric fuel primary pump eliminating manually priming of fuel system, after changing filters _____ _____ _____________ g. Spin on oil, fuel filters and water separator _____ _____ _____________ h. Primary and secondary warning when maintenance is required _____ _____ _____________ 3. Powertrain a. Must have two speed transmission _____ _____ ____________ b. Must reach travel speed in high of 3.4 mph, minimum _____ _____ ____________ c. Maximum drawbar pull should be at least 24,000 lbs. _____ _____ ____________ 4. Undercarriage a. Tracks must have rubber crawler pads installed before delivery for use on asphalt roads to minimize damage to the roads _____ _____ ____________ b. 20” minimum crawler pads or rubber tracks _____ _____ ____________ c. Blade length minimum 8’2” _____ _____ ____________ 5. Hydraulics a. Main system shall have a maximum flow of at least 55 gallons per minute _____ _____ ____________ b. Maximum pressure shall be at least 5,000 PSI _____ _____ ____________ c. Auxiliary hydraulics plumbed to end of arm for attachments with controls on joystick for operation of high and medium pressure tools _____ _____ ____________ d. Boom & stick lowering control valves
