Specifications include, but are not limited to: 1 HEAVY DUTY TRUCK ENTER MAKE AND MODEL > 2 BASE MODEL A) 4X2 Single Axle Truck (SFA Type) B) Conventional Cab, Engine Forward 3 WHEEL BASE A) 160" Minimum 4 CAB TO AXLE A) 85", With 63" Axle to Frame 5 GVWR A) 41,000 LBS minimum 43,000 GVWR 6 ENGINES A) Diesel 8.9L or Equivalent (WET TYPE SLEEVES) B) Air to Air After-Cooling C) Must be 2013 OBD certified and compliant with GHG14 regulations, Must use SCR D) Minimum of 330 horsepower @ 2000 RPM / 1100 lb ft @ 1400 RPM E) Shall have electric cruise control F) Minimum 1000 Watt/115 volt engine block heater G) Clutch Fan, On/Off Type H) Stainless steel engine oil pan if apical I) Radiator- cross flow, Series system, 1228 sq. in. aluminum core & 1167 sq.in. charge air cooler J) PTO adapter off front engine crankshaft (must go under radiator not through it) K) Low coolant level indicator in cab L) Road speed wiring for rear spreader control M) Engine protection plan 7 COOLANT CONDITIONER A) Extended Life Coolant 8 AIR CLEANERS A) Single 9 AIR INTAKE A) Inside, Outside With In-Cab Control 10 TRANSMISSION A) Automatic Allison 3000 RDS 6, close ratio, double overdrive, with PTO Provision 80,000 GVW B) Transmission prognostics enabled C) Stainless Steel Water to oil transmission cooler D) Electric transmission shift control E) Synthetic Lube F) Performance Programming Shifting G) Stainless steel Transmission cooler lines if available H) Oil lever sensor I) Allison TCM inside cab J) Stainless steel PTO Covers If Apical K) Stainless Steel Bolt Kit If Apical L) Neutral at Stop Feature Disabled (Required)
