Specifications include, but are not limited to: Inspections: a. PM 1 Service (2023, 2024, 2025) this inspection will be performed twice a year for the next 3 years and will include the following inspections points. Note: See PM 1.5 Service performed once a year. Cooling Systems: i. Inspect radiator/heat exchanger for leaks, exterior cleanliness and or deterioration ii. Check and record coolant level iii. Check and record coolant freeze protection iv. Obtain coolant sample and send out for laboratory analysis v. Inspect hoses and connections for signs of leaks and/or deterioration vi. Inspect fan drive pulley and fan for signs of wear or cracks vii. Inspect fan belts for signs of cracking or deterioration viii. Confirm jacket water heater is working and record coolant temperature (engine not running) ix. Inspect water pump for any indication of leaks Fuel Systems: i. Inspect fuel water separator (if equipped), drain any water from water/sediment bowl (if equipped) ii. Check and record fuel tank level (if quipped with gauge) iii. Visually inspect fuel tank and fuel piping for any indication of leaks iv. Inspect fuel lines and connections for leaks v. Inspect governor linkage (if equipped) for free movement and signs of wear vi. Record fuel pressure (if equipped) while engine is running Air Intake and Exhaust System: i. Check air filter restriction gauge (if equipped) for amount of filter restriction ii. Inspect filter element visually to confirm it is seating properly iii. Inspect air intake system for any loose components or signs of wear/rubbing iv. Inspect turbocharger(s) (if equipped) for loose intake or exhaust components
