Specifications include, but are not limited to: 2.1 Vehicle Configuration 2.2 The newest model year available Freightliner, International, Kenworth, Peterbuilt and Mack conventional chassis or equivalent with the options listed below or equivalent shall be supplied. 2.2.1 Model year of chassis will be noted on proposal page. 2.2.2 Chassis payment on delivery discount will be noted on proposal page. 2.2.2.1 If bidder applies a chassis price increase contingency it will be noted on the proposal page. 2.2.3 Set back axle – truck straight truck provision. 2.3 General Service 2.3.1 Truck configuration fire service emergency vehicles business segment. 2.3.2 Medium truck warranty. 2.3.3 Expected front axle(s) load: determined by manufacturer and listed in weights and balance documentation indicating remaining useable front axle weight. 2.3.4 Expected rear drive axle(s) load: determined by manufacturer and listed in weights and balance documentation indicating remaining useable rear axle weight. 2.3.5 Expected gross vehicle weight capacity: determined by manufacturer and listed in weights and balance documentation. 2.4 Engine 2.4.1 Cummins 350 hp @ 2000 rpm, 2200 gov rpm, 1000 lb/ft @ 1400 rpm, Cummins l9 options are acceptable base on availability. 2.5 Engine Equipment 2.5.1 One-piece valve cover. 2.5.2 Onboard diagnostics/2010 epa/carb/ghg17 or newest revision 2.5.3 Ember screen and fire-retardant Donaldson air cleaner 2008 carb emission certification - exempted vehicle; no clean idle label required. 2.5.4 Engine mounted oil check and fill 2.5.5 Fire and emergency vehicles engine warning 2.5.6 Dr 12v 275 amp 40-si Quadramount pad alternator with remote 2.5.7 Battery voltage sense 2.5.8. Positive post for jumpstart 2.5.9 Two (2) alliance model 1231, group 31, 12-volt maintenance free 2250 CCA threaded stud batteries. 2.5.10 Battery box frame mounted single battery box frame. Mounted LH side under cab 2.5.11 Wire ground return for battery 2.5.12 Cables with additional frame ground return 2.5.13 Battery box cover will be diamond plate or polished to match step cover material. 2.5.14 Positive load disconnect with cab mounted control switch mounted outboard driver seat.
