Specifications include, but are not limited to: 2 cubic yards 70”x34”x45” 1 each 3 cubic yards 70”x42”x55” 1 each 4 cubic yards 70”x50”x60” 5 each 6 cubic yards 70”x68”x70” 200 each 8 cubic yards 70”x82”x75” 100 each Repair Specifications: All bins have various issues which must be repaired to full working order intended for Solid Waste collection. Each bin must be cleaned inside and out. The outside must be prepared for painting by sanding and/or sandblasting the surface to remove any loose debris, stickers, or other foreign items. ii. The inside must be prepared for painting by removing any loose debris from the surface. The bins must be painted (both internal and external) with high quality enamel paint. The City’s paint color is to be Frazee Hi-Tech “Dumpster” Blue, “Magnet” Gray or White or equivalent as directed and approved before painting begins. All paint must have guaranteed color retention for a minimum of five (5) years. All workmanship and additional materials must be guaranteed for a minimum of one (1) year. Sheet metal replacement should be made utilizing as large sheets as possible to minimize seams. Prior to painting, repairing and/or welding all metal sleeves and doors on front load bins. All welding repairs on the inside surface of the containers should have minimal seams and must be ground down to provide a smooth surface. Replacement of an entire bin bottom must be made to the City’s specifications. i. This would include cutting six (6) inches off the bottom of the container, fabricating a new container bottom, and installing the bottom onto the container, leaving a gap of about four (4) inches between the bottom edge of the old container and the new container floor. ii. The new bottom of each container is to be made from 12-gauge steel. The sides, front, and rear of the new bottom are to be six (6) inches tall and be made from 12-gauge steel. iii. On the underside of the new bottom two (2) – 3-inch x 3/16-inch pieces of channel are to be installed eighteen (18) inches from each container side, running from the front of the container to the back of the container. The ends of the channel are to be flush with the front and rear edges of the container. Four (4) – 3-inch x 6-inch caps are to be welded over the ends of the channel extending up onto the front and rear sides of the container. f. All broken, ripped or warped plastic lids must be replaced with new lids of a like design approved by the City. g. The hinge rods, washers, nuts, and casters must be replaced with new products whenever lids are repaired or replaced. h. The ear tabs holding the hinge rods must be straightened, repaired/replaced, and welded before painting. i. Up to thirty percent (30%) of the bins may contain locking lid mechanisms. These mechanisms must be repaired or replaced to return them to their original working condition. j. Apply (supplied) City insignias and decals, if applicable. k. The bins may only be removed by an appointment coordinated with a Solid Waste Foreman. l. All work must be completed, and the bins delivered back to the City’s Facilities within twenty-one (21) calendar days of the pick-up of each bin. m. After the bins have been refurbished and repainted, the Contractor must deliver the completed items to the same location where they were originally picked up. Delivery of the bins must be coordinated with a Solid Waste Foreman with a minimum of forty-eight (48) hour notice before any delivery.
