Specifications include, but are not limited to: Vehicle installations must follow: • FMVSS 101 - Controls & Identification • FMVSS 107 - Reflective Surfaces • FMVSS 111 - Driver’s Rearward Vision • FMVSS 125 - Hazard Warning Devices • FMVSS 207 - Anchorages of Seats • FMVSS 209 - Rear Shoulder Harness • FMVSS 210 - Seat Belt Anchorages • FMVSS 302 - Flammability of Material • FMVSS 201 - Occupant protection (Air bags, sharp edges, soft surfaces etc) All wires will be installed using professional standards and requirements. Connectors will be crimped and protected with heat shrink tubing or heat shrink connectors when necessary. All other connections and wiring will be protected with super 33 or super 88 electrical tape and split wire loom for extra stability and protection. All vehicle set-ups will be properly documented to identify all components and equipment installed into each vehicle. Documents will also show vehicle number, serial numbers, and DPS asset numbers. All necessary emergency equipment for officer use will be installed in a sturdy but organized vehicle-specific center console including the following: Docking Station Harris 2-way Radio Kenwood 2-way Radio Whelen or Federal Control Unit 12 Volt outlet plugs Cup holders Watchguard Camera System Printer in Armrest Flashlight Charger Stalker Radar 5amp 15amp 10amp 15amp 10amp 7.5amp 5amp 3amp B+ Positive Electrical Current B- Negative Electrical Current Ignition Key-On Power
