Specifications include, but are not limited to: • All aluminum construction with 5052 marine grade • Outer shell constructed of 0.190 thick aluminum minimum • Inner tank and dividers of 0.125 thick aluminum minimum • Each compartment will have ¾” opening for oxygen line access • All welded construction, no rivets. Option #1 Two Pick Up truck distribution tanks • Double walled, insulated, back sloping floor 2” drop from back to front minimum • Outside Dimensions 87”L x 46” W x 27” H • Two - 160 gallon tanks Driver & Passenger side • Bottom and outside walls minimum 2” thick filled with polyurethane foam or polystyrene closed cell • Top of tanks and lids minimum 2” ” thick filled with polyurethane foam or polystyrene closed cell • Frame sides/bottom/top of 2” x 2” x 1/8” square tubing • Two Lids 22” x 59” minimum with stops, Stainless locking latches, heavy duty aluminum hinges that hold lid propped open without slamming shut, 2 stainless steel handle, 4 spring rubber door locks, and close on a gasket to minimize leakage during fish transport (7) • Divider between tanks minimum 1” thick filled with polyurethane foam or polystyrene closed cell (1) • One 12” x 12” sealing slide gate (5) at back of each tank with 8” ID Camlock® (13) with recessed slot in floor for gate to fit into when closed, slide gate should retain contents when camlock is removed • Two aerator mounts at front of each compartment (6) • A manifold to hold 2 oxygen flow meters attached to the front of tank. • Box will have lifting rings and bolt down capabilities for a 3/4T truck (12) () Denotes number on sketch of box Option #2 One Pick-Up and One 4-box (~275 gallon/box) distribution Tanks • PICK-UP Box as Specified in Option #1 • 4-Box Tank overall 13’ length x 5’6” width x 41” height • Double walled, insulated, back sloping floor to discharge • Ram Air Vents Installed on all 4-boxes • One Aerator Mount for each tank • 12” x 12” sealing slide gates at back of each tank with recessed slot in floor for gate to fit into when closed, slide gate should retain contents when next tank is empty or Camlock® is removed, some leakage is expected but should be minimal. • Tank to tank and rear drain should all be 8” diameter round • Each Compartment lid will be a minimum of 32” Wide x 34” Depth
