All correspondence must be made through the Vendor Portal. Specifications include, but are not limited to: 1) Ultra-high molecular weight polyethylene infeed timing screw 2) VPF Servo on timing screw drive with VPF Servo on de-lid drive 3) Powerflex 525 VFD on conveyor 4) 304 stainless steel high washdown construction designed for #10 can size at maximum rate of 60 cpm 5) Stainless steel barrier guarding 6) Torque overload protection through servos/controls 7) Standard input voltage: 480V / 3-PH / 60 HZ with 1 H.P. Frequency Inverter Drive and 24V DC control voltage, 40-amp circuit required 8) Ethernet capable PLC (Compact Logix) 9) Surge tank (customer supplied) - requires minimum of 90 PSI for can opening 10) IP65 Panel view control interface with PLC machine controls mounted to main control box 11) Can opener operation - Right to Left 12) All electrical components needed for electrical control box to include: 1) Incoming power cables; 2) Motor power cables; 3) Holes/Knockouts/Cord-Grips on the electrical enclosure 13) 8 Ft. Stainless Steel Infeed Conveyor to include: 1) Delrin Chain; 2) Electric and Motor: 220/440 3-PH; 3) Powerflex 525 VFD for conveyor 14) Can Rinse & Blow Off to include: 1) Air and Water Nozzles; 2) Drain Pan; 3) Wash Cover (This is for pre-rinsing of the cans prior to opening.) 15) Dump Station includes: 1) Support Frame/Stand; 2) Can Twist; 3) Product Chute 1) Twist cans upside down with backpressure from the timing screw pushing product through along with a slight decline in elevation to assist with dumping of product 2) Sloped stainless steel dump area to filter product to the opening and utilize standard slope. 3) Minimum 38" height clearance for our batch buckets to fit under. 4) Minimum 45" width clearance for our batch buckets to fit under. 16) Primary Pneumatic Vibrator: Vibrate containers once inverted to assist in the evacuation of product. 17) Secondary Pneumatic Vibrator: Vibrate containers once inverted to assist in the evacuation of more viscous products. 18) Stainless Steel Cover/Enclosure for washdown rated pneumatics with stainless steel pneumatic fittings where applicable/available and filter-regulator-lubrication with 1-micron coalescing filter. 19) Lidded Can Sensor: This sensor will detect that the lid is still on the can after the de-lidding process and cycle stop the machine so the operator can intervene to remove the can/lid from the system and restart the machine. 20) Change Parts for #10 can to include: 1) Infeed Screw; 2) Removeable dead plate; 3) Can twist; 4) Can guide rail 21) Pneumatical Can Centering System: This assists with positioning the can directly under the blade used for opening cans, especially for dented cans. 22) Magnetic Grating for Dump Area 23) Pneumatical Punch & Blow System: Can opener will pierce the can bottom, while upside down over the main dumping area, to allow for a pneumatic-assisted air blast into the bottom of the can to assist in evacuating the product from the can. 24) Can Crusher Package to include: 1) Stainless steel frame construction; 2) Epoxy painted 7.5-HP motor; 3) Mechanical design (no hydraulics) 25) Human Machine Interface (HMI)