Specifications include, but are not limited to: UTILITY VEHICLE CHASSIS: 1. 4300 International SBA 4x2 or equal 2. Gross Vehicle Weight rating- 25,500 pounds. 3. Wheelbase- 201 inches. 4. Cab to Axle- 108 inches. 5. Overall length of finished vehicle not to exceed 342 inches 6. Frame – Single frame with 10.125 tall x 3.580 flange x .312 thick, PSI 120,000 heat treated alloy. 7. Front axle – 8,000-pound 50 degree cut. 8. Front suspension – Parabolic Taper leaf 8,000-pound, front auxiliary overloads 2000- pound capacity. 9. Rear axle – 17,500 pounds, single reduction, with 190-wheel ends. Gear ratio: 6.50 with synthetic oil. 10. Rear suspension – 20,000 LB Vari-rate with 4000-pound overloads. 11. Speed – Geared road speed approximately 65 MPH. 12. Engine control- Remote mounted; provision for; includes wiring for body builder installation of PTO controls; with ignition switch control for CEC II electronic engines. 13. Diesel Engine – Electronic controlled wet sleeve design with a minimum of 466 cubic inch displacement 220 HP and 540-foot pounds of torque. Engine warranty to be a minimum of 3 years/150,000 miles. Electronic cruise control with integrated throttle. Steering wheel controls. The engine shall include the following: *fuel/water separator; mounted on engine and fuel filter in a single assembly *cold starting equipment; intake manifold electric grid heater with engine ECM control *engine shutdown; electric, key operated
