Specifications include, but are not limited to: OPTION 1: Contractor will provide all labor, equipment, materials, incidentals, and traffic control necessary to cold mill approximately 34,472’ x 34’ at a depth of .15 feet and produce, haul, place, tack, and compact approximately 12,746 tons of 1/2” Commercial Plant Mix Grade S 58V-34 asphalt mix material. The overlay shall be paved .15 feet thick and approximately 34 feet wide. Sinusoidal center line rumble strips are to be included for the length of the project. Contractor shall provide all labor, equipment, materials, traffic control, and incidentals necessary to produce, haul, place, roll, and broom approximately 126,397 square yards of laid-in-place chip seal. The chip seal will be approximately 6.15 miles long and 33 feet wide. Contractor shall provide CHFRS-2P asphalt emulsion and Type 1 chips. Traffic control with pilot cars must be maintained until dusk or fading light each workday as determined by the Project Manager. The emulsion application rate for chip seals is estimated at .45 gallons per square yard. The cover material application rate is estimated at 25 pounds per square yard. OPTION 2: Contractor will provide all labor, equipment, materials, incidentals, and traffic control necessary to cold mill approximately 64,416’ x 34’ at a depth of .15 feet and produce, haul, place, tack, and compact approximately 23,818 tons of 1/2” Commercial Plant Mix Grade S 58V-34 asphalt mix material. The overlay shall be paved .15 feet thick and approximately 34 feet wide. Sinusoidal center line rumble strips are to be included for the length of the project. Contractor shall provide all labor, equipment, materials, traffic control, and incidentals necessary to produce, haul, place, roll, and broom approximately 236,192 square yards of laid-in-place chip seal. The chip seal will be approximately 12.2 miles long and 33 feet wide. Contractor shall provide CHFRS-2P asphalt emulsion and Type 1 chips. Traffic control with pilot cars must be maintained until dusk or fading light each workday as determined by the Project Manager. The emulsion application rate for chip seals is estimated at .45 gallons per square yard. The cover material application rate is estimated at 25 pounds per square yard.