Specifications include, but are not limited to: Purchasing autopsy system equipment for the Forensic Science Lab. The wall mounted dissecting stations specify the desired width in order to fit the dimensions required in the lab design. Widths may vary during the approval process by up to 2 inches. Equipment installation to be provided by the State. Wall Mounted Dissecting Station, Center, 119” Wide, Main Autopsy Standard Features: • All Type 304 stainless steel construction with heliarc welded seams and joints, ground and polished to a smooth finish • Deluxe Aspirator and vacuum breaker with reverse flow for additional waste removal; “reverse flow” feature instantly relieves suction clogging by providing a reverse pressure of water. • Dual Hot and Cold water fixture with convenient goose-neck faucet and wrist-blade handles. • Spray Hose Assembly with cold water control valve, nozzle and 10 feet of flexible hose • Dissecting Area Rinse Assembly with cold water control valve • Heavy-duty Commercial Waste Disposal, 1/2 HP • Fluorescent Lighting Fixtures over each Dissecting Area • Large Instrument Drawer • Exhaust Ducts over each Dissecting Wing must tap from the rear of the unit • Large radii on all inside corners for easy cleaning and required sanitation. • Large single-compartment sink with rapid and positive drainage • Cart-to-sink Locking Mechanism with slide latch which can be accessed from either side of the carrier • Waterproof electrical outlets and switches • Plumbing and Electrical lines are factory installed and require only minimum installation • Complete back siphon protection provided by reduced pressure principle assembly
