Awardee will be required to provide a sample of each, then, sample approval prior to delivery of remaining quantities. Estimated sample review start date 04/25/2024. Estimated production set to begin 7/01/2024.
SUPPORT FOR MK 8 PALLET, FFP
SUPPORT, PALLET, USED ON MK 8-0 PALLETS PER NAVSEA DRAWING No. 1279594 REVISION B, MANUFACTURED FROM ASTM A1011/A1011M, 1 GAGE HOT ROLLED STEEL, CS TYPE B. Support: 12 required per pallet
Certificates of conformance must be signed by the vendor’s Quality Assurance Representative.
Material certifications should list heat values proving the grade of material used.
Certificate of Conformance should state-
“This support conforms to the specifications listed in Drawing No. 1279594 Revision B.”
Metal Certificate must state-
“Material conforms to ASTM A1011 / A1011M HOT ROLLED STEEL SHEET, CS Type-B.”
SPREADER FOR MK 8 PALLET, FFP
SPREADER, PALLET, USED ON MK 8-0 PALLETS PER NAVSEA DRAWING No. 1279595 REVISION B, MANUFACTURED FROM ASTM A1011/A1011M, 11 GAGE HOT ROLLED STEEL, CS TYPE B. Spreader: 4 required per pallet .
Certificates of conformance must be signed by the vendor’s Quality Assurance Representative
Material certifications should list heat values proving the grade of material used.
Certificate of Conformance should state-
“This spreader conforms to the specifications listed in Drawing No. 1279595 Revision B.”
Metal Certificate must state-
“Material conforms to ASTM A1011 / A1011M HOT ROLLED STEEL SHEET, CS Type-B.”
RUNNER FOR MK 8 PALLET, FFP
RUNNER, PALLET, USED ON MK 8-0 PALLETS PER NAVSEA DRAWING No. 1279596 REVISION B, MANUFACTURED FROM ASTM A1011/A1011M, 11 GAGE HOT ROLLED STEEL, CS TYPE B. Runner: 3 required per pallet
Certificates of conformance must be signed by the vendor’s Quality Assurance Representative
Material certifications should list heat values proving the grade of material used.
Certificate of Conformance should state-
“This spreader conforms to the specifications listed in Drawing No. 1279596 Revision B.”
Metal Certificate must state-
“Material conforms to ASTM A1011 / A1011M HOT ROLLED STEEL SHEET, CS Type-B.”
ALL MATERIAL MUST HAVE MILL TEST REPORTS, MUST BE FREE OF PAINT, HAVE LIGHT TO NO RUST, BE TRANSPORTED COVERED, ALL DRAWING DIMENSIONAL TOLERANCES APPLY. CERTIFICATE OF CONFORMANCE REQUIRED TO ABOVE SPECIFICATIONS. SEE ATTACHED DRAWING FOR EACH, MUST PROVIDE SPEC SHEET AT THE TIME OF QUOTE.
BIDS SUBMISSIONS ONLY VIA EMAIL: andrea.jones36.civ@army.mil
[ATTACH BID DOCUMENTS, SUBMIT TO LISTED EMAIL]
Any changes to the solicitation shall also be posted to this web site and it is the contractor's responsibility to check site daily for any posted changes. All contractors who provide goods/services to the DOD must have a current active registration at System for Award Management (SAM) - https://www.sam.gov.
