Specifications include, but are not limited to: Compact Track Loader 3475 lbs. Rated Operating Capacity with 80” industrial bucket and 40” planer. Engine a. Loader shall have a 4-cylinder, liquid-cooled diesel; at a minimum of 92.0 hp. b. Loader engine shall a have minimum torque of 258.1 lb.-ft. at 1600 RPM. c. Loader engine shall be turbocharged. d. Engine displacement shall be no more than 208.0 cubic inches (3.4L). e. Loader shall be equipped with a hydraulically driven, variable speed cooling fan. f. Engine must meet EPA Tier 4 Emission compliance without the aid of a diesel particulate filter. g. Spark arrestor device, dual element air cleaner and glow plug cold weather assist shall be provided as standard equipment. h. Cold weather assist shall be automatically activated. i. Air cleaner shall be a dry replaceable cartridge with a safety element and precleaner. j. Air intake pre-cleaner shall be included in the air cleaner housing. k. An additional system to increase pre-cleaner efficiency shall be standard. l. Fuel recirculation system that can bypass the fuel cooler to aid in cold weather operation shall be standard equipment. m. Loader shall limit engine RPM until specified engine operating temperature is attained to protect the engine from premature wear due to cold temperatures. n. Engine coolant shall have freeze protection to -34ºF (-37ºC). o. Loader shall be equipped with a Diesel Oxidation Catalyst (DOC). p. Engine shall utilize an Engine Gas Recirculation (EGR) system. q. Loader shall be equipped with a Selective Catalytic Reduction (SCR) system. r. Loader shall require Diesel Exhaust Fluid. s. Loader shall indicate when the SCR system is in DeSox. t. An SCR DeSox Inhibit Switch shall be available. u. Loader shall be equipped with a Dosing Control Unit to electronically monitor and control the performance of the SCR system. v. The loader’s fuel injection system shall include a High-Pressure Common Rail (HPCR). w. Fuel filter shall have a 4 micron C rating at 99.6% efficiency. x. Loader shall be equipped with a dual-path cooling system. y. Battery shall be 12 volts with a minimum of 1,000 cold-cranking amps. z. Alternator shall be a minimum of 120 amp. aa.The starter shall be a 12-volt; 3.62 hp (2.7 kW), gear type. bb.Engine accessory belts shall not require any adjustments. cc. Engine shutdown shall be provided as standard equipment and shall monitor engine coolant temperature, engine oil pressure, and engine RPM to help prevent engine damage. dd.An engine block heater is required. Drive System a. Shall have a fully hydrostatic track drive. b. Transmission shall be infinitely variable tandem hydrostatic piston pumps, driving two fully reversing hydrostatic motors. c. Hydrostatic piston pumps shall be belt driven from the engine. d. Undercarriage shall be solidly mounted to the loader main frame. e. Shall have 5 triple flange forged steel rollers per side. f. Shall use single-flange forged steel rear idlers. g. Shall use dual flange forged steel front idlers. h. Steel rollers and idlers shall be permanently sealed and lubricated requiring no routine maintenance.
