Specifications include, but are not limited to: 84” CA Knapheide Service Body model 6132D54 or equivalent Dual rear wheels Overall width 94” Floor width 54” Pack depth 20” Pack height 40” Exterior finish standard bright white coat Bright white compartment interior One (1) aluminum gas fill cup LED compartment lighting, strip lights in all compartments Three point T-handle stainless steel Type 304 stainless steel hardware Type 304 stainless steel door hinge Vinyl covered stainless steel cable door stops or spring over center linkage on vertical doors and chain for horizontal Knapheide lining on tops, bed sides, floor, tailgate and bumper. Linex is acceptable on the bed. Clear vinyl or aluminum rock guards E-track in cargo area-upper and lower, streetside. Weatherproof gasket around doors One piece molded doors with automotive finish both sides Recessed door jambs Rubber strap type galva-grip step on both sides of rear bumper in arms reach of grab handle Flow through ventilation system Light adaptor for specified chassis LED lighting package (stop/tail/turn & marker only; standard reverse light & amber strobes) surface mount light with 9 selectable patterns and built in reflectivity with additional wire harness for strobe operation Chassis lighting kit for body Full width step type bumper, stainless steel extruded grip step design or glavaneel steel and galva grip punched. Standard bumper depth. Aluminum baskets on top of compartments, both sides 10” tailgate, automotive style, DRW Splash guards for rear wheels 2000W Tripp Lite power invertor mounted behind the seat passenger. Invertor wired through 80 amp solenoid and a fuse block. Solenoid and fuse block to be mounted as close to the location of the truck batteries as possible. Control side of solenoid to be wired to number 4 Body Builder factory switches on dash. Invertor power and ground must be wired directly to the batteries.
