Specifications include, but are not limited to: TYPICAL UNIT: PALFINGER PAL PRO 39-11SSCS, KNAPHEIDE 6132DLR-30K, or State of Alaska approved manufacturer and model; provided all of the following minimum specifications are met. Any other manufacturer and model offered must be pre-approved before bid submittal. CHASSIS: Chassis will be Ford 17,500 lb. GVWR. With gas engine. Chassis does not have PTO but is PTO capable. BODY: Torsion box understructure with 14-gauge, minimum, galvanneal steel. The floor shall be 12-gauge, minimum, with treadplate pattern. Floor width: 50-54 inches. Body length: 130-134 inches. Body width: 98 inches, maximum. Height: 40-44 inches. The front of the body shall include a headache rack. 4 cargo tie-downs inside the bed. D-ring type with 6,000 lbs. capacity, minimum. Slam tailgate with center latch and hinge stop(s). Outrigger Bumper: Shall include 2-inch receiver hitch and 7-pin flat connector. Must include vice mounting area, curbside. Shall include pass-through compartment with a door on each side. 21-inch-deep step and work surface. Grip strut and or grip tape shall be included for all step surfaces. Lower height flexible step on both sides of the bumper with handholds for safety. SIDE COMPARTMENTS: All compartment doors shall have t-handle latches. All doors shall have seals to prevent dust and moisture intrusion. All hinges must be aluminum or stainless steel and continuous. Vertical doors shall include a spring mechanism to prevent involuntary swing. Compartments shall be approximately 18 inches inside depth. Master locking system to allow one entire side of compartments to be locked with a padlock. Curbside front vertical compartment: Extended height compartment. Shall be 60-66 inches tall. Gas bottle retainers for 2 bottles. Minimum of 3 adjustable shelves. Curbside second vertical compartment: 2 adjustable shelves with dividers. Curbside middle horizontal compartment:1 adjustable shelf with dividers. Curbside rear compartment (crane compartment): Outrigger controls. Electrical switch panel for lighting. Hose reel and Streetside front compartment: Aluminum mechanic drawers: 3-inch drawers, Qty: 3, minimum. 5-inch drawers, Qty: 2, minimum. 7-inch drawer, Qty: 1, minimum. Streetside second vertical compartment: 2 adjustable shelves. Streetside horizontal compartment: 1 adjustable shelf with dividers. Streetside rear compartment: 2 adjustable shelves with dividers. CRANE: Acceptable Manufacturers: PALFINGER or STELLAR. Must be hydraulic or electric crane. Maximum Rated Capacity: 3,200 lbs., minimum. Rotation: 360 degrees, minimum, non-continuous.
