Specifications include, but are not limited to: The work shall consist of cleaning, preparation, waterproofing and coating of an existing metal roof with a pitch of ½:12 covering approximately 39,000 SF over two levels The Waterproof Membrane System shall be a monolithic, multi-layered, seamless, leak-free system. The Waterproof Membrane System shall come with a 15-year material and labor warranty. All fasteners shall be tightened or replaced. If necessary, additional fasteners shall be installed to secure any loose panels. The entire roof shall be pressure washed and cleaned of all dirt and debris. Every fastener shall be encapsulated with a fluid applied waterproofing membrane to provide a tight waterproof seal. All vertical seams shall be sealed and waterproofed using a butyl backed tape and a fluid applied waterproofing membrane or approved equivalent. All other seams shall be sealed and waterproofed using a butyl backed tape and a fluid applied waterproofing membrane or approved equivalent. All penetrations shall be flashed and waterproofed using a butyl backed tape and a fluid applied waterproofing membrane or approved equivalent. For oddly shaped penetrations, a fiber-based fluid applied waterproofing membrane shall be used. After all fasteners, vertical and other seams, and penetrations are properly treated and dried, the entire roof shall receive a minimum of two coats of ASTEC Re-Ply #2000 finish coating or approved equivalent at a rate of 100 sq ft per gallon per coat.